- Buy 5 for $1,326.00 each and save 5%
- Buy 10 for $1,256.00 each and save 10%
The 100A40 PWM servo drive is designed to drive brush type DC motors at a high switching frequency. A single red/green LED indicates operating status.
The drive is fully protected against over-voltage, under voltage, over-current, over-heating and short-circuits across motor, ground and power leads.
Furthermore, the drive can interface with digital controllers or be used stand-alone and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14- turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
|Product Category||Amplifiers - Analog Type|
|Manufacturer||Advanced Motion Controls|
|Short Description||80-400 VDC Input; 50A continuous / 100A peak | 19kW Output @ 400 VDC in|
|Min Input Supply Voltage (VDC)||80|
|Max Input Supply Voltage (VDC)||400|
|Max Continuous Output Current (A)||50|
|Max Peak Output Current (A)||100|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load)|
|Operating Mode||Analog Feedback, Current (Torque) Mode, Voltage (BEMF / Open Loop) Mode, Velocity Mode|
|Series||Brushed Analog Series,vendor=Advanced Motion Controls|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||65|
|Max Operating Temperature (°F)||149|
|Max Rated Power (W)||19000|
Sample image only. Product may differ