- Buy 5 for $542.00 each and save 5%
- Buy 10 for $513.00 each and save 10%
The A50A200I PWM servo drive is designed to drive brush type DC motors at a high switching frequency. A single red/green LED indicates operating status. The drive is fully protected against over-voltage, under-voltage, over-current, over-heating and short-circuits across motor, ground and power leads.
Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
This drive can use a tachometer for velocity control.
|Product Category||Amplifiers - Analog Type|
|Manufacturer||Advanced Motion Controls|
|Short Description||40-175 VDC Input, 25 A Cont. (50 Peak), Isolation option|
|Min Input Supply Voltage (VDC)||40|
|Max Input Supply Voltage (VDC)||175|
|Max Continuous Output Current (A)||25|
|Max Peak Output Current (A)||50|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load)|
|Operating Mode||Current, IR Compensation, Tachometer Velocity, Voltage|
|Series||AxCent Series,vendor=Advanced Motion Controls|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||65|
|Max Operating Temperature (°F)||149|
|Max Rated Power (W)||4156|
Sample image only. Product may differ