- Buy 5 for $309.00 each and save 5%
- Buy 10 for $293.00 each and save 10%
The AB15A100 PWM servo drive is designed to drive brushless and brushed DC motors at a high switching frequency. A single red/green LED indicates operating status.
The drive is fully protected against over-voltage, under-voltage, over-current, over-heating and short-circuits across motor, ground and power leads.Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. This drive can use quadrature encoder inputs for velocity control.
|Product Category||Amplifiers - Analog Type|
|Manufacturer||Advanced Motion Controls|
|Short Description||20-80 VDC Input, 7.5 A Cont. (15 Peak)|
|Min Input Supply Voltage (VDC)||20|
|Max Input Supply Voltage (VDC)||80|
|Max Continuous Output Current (A)||7.5|
|Max Peak Output Current (A)||15|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Duty Cycle (Open Loop), Encoder Velocity|
|Feedback||Hall Effect Sensors, Incremental Encoder|
|Series||AxCent Series,vendor=Advanced Motion Controls|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||65|
|Max Operating Temperature (°F)||149|
|Max Rated Power (W)||570|
Sample image only. Product may differ