- Buy 5 for $385.00 each and save 5%
- Buy 10 for $365.00 each and save 10%
The AB20A200 PWM servo drive is designed to drive brushless and brushed DC motors at a high switching frequency.
A single red/green LED indicates operating status. The drive is fully protected against over-voltage, under-voltage, over-current, over-heating and short-circuits across motor, ground and power leads. Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. This drive can use quadrature encoder inputs for velocity control.
See Part Numbering Information on last page of datasheet for additional ordering options. Download the installation manual for the AxCent™ Series drive family at www.a-m-c.com.
|Product Category||Amplifiers - Analog Type|
|Manufacturer||Advanced Motion Controls|
|Short Description||40-175 VDC Input, 12 A Cont. (20 Peak) Output|
|Min Input Supply Voltage (VDC)||40|
|Max Input Supply Voltage (VDC)||175|
|Max Continuous Output Current (A)||12|
|Max Peak Output Current (A)||20|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Duty Cycle (Open Loop), Encoder Velocity|
|Feedback||Hall Effect Sensors, Incremental Encoder|
|Series||AxCent Series,vendor=Advanced Motion Controls|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||65|
|Max Operating Temperature (°F)||149|
|Max Rated Power (W)||1995|
Sample image only. Product may differ