Product Details

AB250A060 servo amplifiers are designed to drive brushless DC motors at a high switching frequency. It is fully protected against over-voltage, over-current, over-heating, under-voltage and short-circuits.

This model interfaces with digital controllers or can be used as a stand-alone drive and requires only a single unregulated DC power supply or battery. A single red/green LED and a single digital output indicate operating status. Loop gain, current limit, input gain, and offset can be adjusted using 14-turn potentiometers.

The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.It will accept tachometer input, quadrature encoder inputs, or Hall sensor inputs for velocity control.

Features

More Information
Manufacturer	Advanced Motion Controls
Max Input Supply Voltage (VDC)	54.00
Motor System	Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)
Operating Mode	Current, Duty Cycle, Duty Cycle (Open Loop), Hall Velocity, IR Compensation, Velocity, Voltage
Configuration	Vehicle Mount
Min Operating Temperature (°C)	0.00
Min Operating Temperature (°F)	32.00
Max Operating Temperature (°C)	75.00
Max Operating Temperature (°F)	167.00
Number of Axes	1
Drive Architecture	Analog
Max Rated Power (W)	7695
Max Continuous Output Current (A)	150.00
Max Peak Output Current (A)	250.00
Setup	Manual
Product Category	Motor Controllers for Electric Vehicles